Table of Contents
Advertisement
1
Chapter
Note
• Be sure to install the latest software.
Refer to "UPDATING YOUR MACHINE'S
SOFTWARE" on page 123.
NAMES OF MACHINE PARTS
Main Parts
a
1 Top cover
2 Pretension disk (page 25)
3 Thread guide for bobbin winding (page 25)
4 Spool pin (page 26)
5 Spool cap (page 24)
6 Supplemental spool pin (page 24)
7 Bobbin winder (page 24)
8 LCD (liquid crystal display) (page 15)
9 Speaker
0 Operation buttons (page 10)
A Embroidery unit (page 34)
B Thread cutter (page 30)
C Thread guide plate (page 26)
D Connector for the presser foot (page 114)
E Handle
Carry the machine by its handle when transporting the
machine.
GETTING READY
NAMES OF MACHINE PARTS
F Presser foot lever
You cannot use the presser foot lever after the presser foot has
been raised using
(Presser foot lifter button).
G Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
H Main power switch (page 13)
I Power cord receptacle (page 14)
J USB port for mouse (page 24)
K USB port
L Handwheel
Turn the handwheel toward you (counterclockwise) to raise and
lower the needle.
Needle and Presser Foot Section
a
1 Screw for embroidery foot (page 114)
2 Embroidery foot
The embroidery foot helps control fabric flexibility for better
stitch consistency.
3 Bobbin cover (page 27)
4 Needle plate cover (page 27)
5 Needle plate (page 113)
6 Needle bar thread guide (page 30)
7 Needle clamp screw (page 32)
1
9
Advertisement
Table of Contents
