Operation Keys - Baby Lock Jubilant BL80B Instruction And Reference Manual

Names of Machine Parts
Measurements on the needle plate, bobbin cover (with
markings) and needle plate cover
The measurements on the bobbin cover are references for
patterns with a middle (center) needle position. The
measurements on the needle plate and the needle plate cover
are references for stitches with a left needle position.
a
b
1 For stitches with a middle (center) needle position
2 For stitches with a left needle position
3 Left needle position <inch>
4 Left needle position <cm>
5 Middle (center) needle position on the bobbin cover
(with markings) <inch>
6 Left needle position on the needle plate cover <inch>
6
■ Operation buttons
b
a
c
1 "Start/Stop" button
Press the "Start/Stop" button to start or stop sewing.
d
2 Reverse stitch button
Press the reverse button to sew reverse or reinforcement
stitches depending on the selected stitch pattern.
3 Reinforcement stitch button
Press the reinforcement button to sew a single stitch
e
repeatedly and tie-off. (page 25)
For decorative stitches, press this button to end with a full
stitch instead of at a mid-point.
f
The LED beside the button automatically lights up while the
stitch is being sewn and goes off when sewing is finished.
4 Needle position button
Press the needle position button to raise or lower the needle.
Pressing the button twice sews one stitch.
5 Sewing speed controller
Slide the sewing speed controller to adjust the sewing speed.
■ Operation panel and operation keys
1 LCD (liquid crystal display)
Selected stitch pattern settings and messages are displayed.
(page 10)
2 Stitch length keys
Press stitch length keys to adjust the stitch length. (page 27)
3 Stitch width keys
Press stitch width keys to adjust the stitch width. (page 27)
4 Needle mode selection key (single/twin)
Press needle mode selection key to use the twin needle. Each
press of this key switches between the twin needle mode and
the single needle mode. (page 49)
5 Automatic reverse/reinforcement key
Press Automatic reverse/reinforcement key to use the
automatic reverse/reinforcement stitching function. (page 25)
c d e