Assembly - Ryobi BGH826 Operator's Manual

WARNING:
Always disconnect the bench grinder from the power
source before performing any assembly or adjustment.
Failure to do so could result in accidental starting resulting
in possible serious personal injury.
SPARK DEFLECTOR
See Figure 4.
Using the two phillips head screws, washers, and lock
washers, attach the spark deflector to the top of the wheel
guard.
Adjust the spark deflectors to within 1/16 in. (1.6 mm) of the
grinding wheel. Tighten screws securely.
WARNING:
Always spin the wheel by hand before turning on the
grinder to make sure the spark deflector doesn't hit the
grinding wheel.
WARNING:
Always make sure your bench grinder is securely
mounted to a workbench or an approved workstand.
Failure to do so could result in an accident resulting in
possible serious personal injury.
SHIELD BRACKET ASSEMBLY
See Figure 5.
Note: The hardware used for assembling the safety shields
to the shield brackets has been preassembled and
prepackaged.
Remove the two phillips head screws, washers, and hex nuts
from the shield bracket. Fit the shield bracket to the top of the
safety shield. Reattach the screws, washers, and hex nuts
taking care not to tighten the screws so tight as to crack the
plastic. Repeat for the other shield bracket and safety shield.
WARNING:
To prevent personal injury, never operate the bench
grinder unless the safety shields and spark deflectors
are properly installed and in place.

ASSEMBLY

SHIELD ROD
WASHER
LOCK
WASHER
HEX NUT
Page 9
SPARK DEFLECTOR
CARRIAGE
BOLT
WASHER
LOCK
HEX NUT
WASHER
SAFETY
SHIELD
WASHER
SCREW
LOCK
WASHER
Fig. 4
PHILLIPS SCREW
SHIELD
BRACKET
Fig. 5