Assembly - Ryobi BGH826 Operator's Manual

MOUNTING SAFETY SHIELDS
See Figures 6.
Mount the left and right shield rods to the inside of the wheel
guards using the clamp brackets, hex bolts (8 mm x 14 mm),
and washers (8 mm).
Use the illustration as a guide to determine which shield rod
is mounted on the left and which shield rod is mounted on the
right of the grinder.
Once shield rods are firmly in place, slide the shield bracket
onto the shield rod. Tighten the carriage bolt leaving it loose
enough to allow the safety shield to be raised and lowered
easily.
WORK REST
See Figure 7.
Before attempting to mount the work rest, remove the hex nut
and star washer from the phillips screw. Place the work rest
over the phillips screw before replacing the hex nut and star
washer. Using the hex bolt (5 mm x 10 mm) and washer
(5 mm), secure the work rest against the inside of the wheel
guard.
Before tightening the bolts, adjust the gap between the
grinding wheel and the work rest to a maximum of 1/16 in.
(1.6 mm). Tighten securely.

ASSEMBLY

CLAMP BRACKET
WASHER
HEX BOLT
Page 10
SHIELD ROD
HEX BOLT
WASHER
Fig. 6
PHILLIPS
SCREW
WORK
REST
STAR
WASHER
HEX NUT
Fig. 7