Kgp-2A/ 2B; Install Kgp-2A/ 2B; Configuration Using Kpg-89D - Kenwood TK-2180 Modification Information

2 CONNECT OPTIONAL DEVICES
2.4

KGP-2A/ 2B

(TK-7180/ 8180 only)
You can connect the GPS receiver (KGP-2A/ 2B) to the
TK-7180/ 8180 to utilize the location data of the
transceiver. This section describes how to install the
KGP-2A/ 2B to the TK-7180/ 8180 transceivers.

2.4.1 Install KGP-2A/ 2B

1. Connect the KCT-40 cable to the transceiver.
(Refer to 2.2 KCT-40 Cable.)
2. Connect the KCT-40 cable to the KGP-2A/ 2B.
3. Turn the transceiver ON.
The KGP-2A/ 2B are also automatically turned ON.

2.4.2 Configuration using KPG-89D

1. Run the KPG-89D.
2. Select
"Program" > "Read Data from the Transceiver".
You can also click the
The Read Data from the Transceiver window appears.
3. Click "Read".
The KPG-89D starts reading the configuration data
from the transceiver.
4. Select
"Edit" > "Extended Function"
The Extended Function window appears.
5. Click the AUX tab.
16
icon on the Toolbar.
.
Modification Information
6. Select "KGP-2A/ 2B" from the External Device
pulldown menu.
The necessary functions to operate the KGP-2A/ 2B
are automatically assigned to each port.
7. Select
"Program" > "Write Data to the Transceiver"
The Write Data to the Transceiver window appears.
8. Click "Write".
The configuration data is written to the transceiver.
Note:
# You must have the KPG-73D to configure the KGP-2A/ 2B.
# You must configure the port logic state in the following conditions
in the Edit pulldown menu > the Hardware Setup window to
interface with the KGP-2A/ 2B function port.
Table 2-14 Transceiver Port Logic Configuration
SQ Squelch Detect Input
DISP TX Display Off Output
Transmitter Active Sense
TXS/ LOK
Input
AM Speaker Mute Output
MM Mic Mute Output
.
Active Low
Active Low
Active Low
Active Low
Active Low
Version: 1.13 USA