Siemens Gigaset 2420 System User Manual page 52

Call Barge In On
The Call Barge In feature allows you to interrupt an active call of a non-Gigaset 2420 phone on a shared line. Call Barge In is
possible only at the desk station.
The desk station and cordless handsets can share a line with non-system phones, but calls on the shared line can be interrupted by
the non-system phones. You can prevent the desk station from interrupting non-system phone calls by setting the Call Barge In
feature.
To enable/disable Call Barge In, scroll to the "Call Barge In Qn" display and press SELECT. Adjust the feature by
pressing SELECT and press MENU to back out of the menu without changing the setting.
When Call Barge n is enabled and the line is in use, the line key flashes. If you barge .in by pressing the flashing line key at the
desk Station, the line key stops flashing and the display changes. You will not see Caller ID information.
Change System PIN
Each desk station and cordless handset has its own PIN (personal identification number( which protects system configurations
and personal information on that phone. Each phone is assigned the Gigaset 2420 default PIN number, 0000 zeros), the factory.
in
Scroll to the "Change System PIN" display and press
SELECT. Enter the new PIN, press SELECT, and confirm
the PIN. Press SELECT. Write the new PIN in Appendix C
Programming Worksheets.
Factory Defaults
Your telephone system comes with factory default settings.
If you restore the factory defaults, the settings for the
Answering System, Directory, and Call Logs will all be reset.
All entries from the Directory will be deleted.
To reset the desk station's factory defaults, scroll to the Factory Defaults" display and press SELECT. Press SELECT again
when prompted. To cancel the task, press MENU.
See Appendix C Programming Worksheets for a complete listing of all factory default settings. See Local Settings later in this
chapter for information about restoring the cordless handset's factory defaults.
Line Data
The Line Data menu allows you to make technical adjustments. You probably will not need to change these settings.
Flash Key Short
The FLASH key can be used In conjunction with Call Waiting. If you have Call Waiting and you press the FLASH key, you
send a signal to the telephone company indicating that you are willing to accept a call. The telephone company may require a
flash signal of a certain length.
To set the length of the flash signal, scroll to the "Flash Key Short" display. Adjust the setting by pressing SELECT (Qn for
short, Qff for long).