Ryobi BT3000 Operator's Manual page 6

TO ASSEMBLE RE600 ELECTRONIC ROUTER
TO ROUTER MOUNTING PLATE
See Figures 5 and 6.
1. Remove the subbase screws and subbase from your
router.
2. Figure 5 illustrates the correct orientation of parts and
pieces for mounting your router to its mounting plate.
3. Place router upside down on a workbench and align
mounting plate holes with tapped holes in the base of
your router.
4. The switch handle of router should be facing the squared
end of mounting plate. See Figure 5.
5. Using the 8 mm flat head screws provided with your
router, secure mounting plate to router.
6. Once properly assembled, your router and mounting
plate assembly should be similar to the illustration
shown in figure 6.
7. Tighten screws securely.
TO ASSEMBLE MOUNTING PLATE WITH
ROUTER ATTACHED TO ACCESSORY TABLE
See Figure 7.
1. Place mounting plate under accessory table as shown
in figure 7. Note: If desired you can remove accessory
table, attach mounting plate with router, then reassemble
complete assembly to your saw.
2. Secure mounting plate to accessory table using the four
#1/4-20 x 1/2 in. flat head screws provided.
3. Tighten screws securely.
INSTALLING ROUTER BIT
Follow the instructions in the operator's manual of your router
for this procedure. Install router bit and tighten securely in
collet.
CAUTION:
Check to make sure it will not strike the accessory table or
any metal surface.
TO ASSEMBLE THROAT PLATE
See Figure 7.
Orient the throat plate as shown in figure 7, align tab with slot
in accessory table, then place throat plate in recessed area
of accessory table. Recheck router bit to make sure it will
not strike the throat plate.
TO ASSEMBLE TABLE CLAMPING BRACKET
See Figure 8.
The lever on the accessory table will tighten it securely to the
front rail of your BT3000. However, the weight of your router
and mounting plate, etc. may cause accessory table to be
loose or have movement at the rear of the accessory table.
To avoid this, install the table clamping bracket supplied with
this kit. It can be used with a router mounted, with a jig saw
mounted, or if desired it can be used with your BT3000 during
normal use.
ROUTER MOUNTING (Cont'd)
8 MILLIMETER
SCREWS
ROUTER
MOUNTING
PLATE
ROUTER
WITH MOUNTING
PLATE ATTACHED
Page 6
RE600
ELECTRONIC
ROUTER
FRONT OF ROUTER
Fig. 5
Fig. 6
THROAT PLATE
#1/4-20 SCREWS
ACCESSORY TABLE
SLOT
Fig. 7