Ryobi BT3000 Operator's Manual page 5

TO INSTALL GUIDE FENCE BRACKETS
See Figure 4.
1. Align each guide fence bracket with two of the special 5/16 in. T-nuts in channel on top of rip fence.
2. Secure guide fences to rip fence with 5/16 in. washers and 5/16 in. x 1/2 in. knob bolts supplied. Note: As shown in
figure 4, center T-nut is not used with guide fences.
TO INSTALL POST
See Figure 4.
1. Place spacer provided on threaded end of post.
2. Thread post thru spacer into remaining 5/16 in. T-nut in top channel of rip fence.
3. Tighten post securely with an adjustable wrench. Note: Adjustable wrench will fit flats on top of post.
TO INSTALL DUST COVER AND PIVOT ASSEMBLY
See Figure 4.
1. Place dust cover and pivot assembly on post as shown in figure 4.
2. It will slide up and down post as needed. When desired location is achieved, secure it in place by tightening knob nut
attached to carriage bolt.
DUST COVER AND PIVOT ASSEMBLY
5/16 in. WASHERS
GUIDE FENCE BRACKET
ROUTER MOUNTING (Cont'd)
KNOB NUT
FLATS ON POST
POST
KNOB BOLTS
CARRIAGE BOLT (NOT SHOWN)
SPACER
RIP FENCE
Page 5
T-NUTS
Fig. 4