Ryobi BT3000 Operator's Manual page 4

Read these instructions completely before beginning assembly of this kit.
WARNING:
The saw's motor cord must be disconnected from the
receptacle provided on the saw when using this kit with
a Router or Jig Saw mounted to the accessory table.
The power supply cord of the Router or Jig Saw must be
plugged into the receptacle and the saw's master switch
must be used to turn the Router or Jig Saw "ON" or
"OFF".
IMPORTANT
This router kit has been specifically designed for use with the
Ryobi Model RE600 Electronic Router Only. The hole
pattern on the mounting plate has not been drilled to
accommodate other routers on the market. Special mounting
screws are provided with the RE600 to insure safe, secure
mounting.
TO INSTALL T-NUTS FOR GUIDE FENCE
BRACKETS
See Figure 2.
This kit requires that five of the special 5/16 in. T-nuts
provided fit in the top channel of the rip fence on your BT3000
table saw. The first T-nut is required between the two
adjustment screws on top of the rip fence.
TO INSTALL:
1. Place rip fence against saw blade as shown in figure 2
and lock in place. This will insure that rip fence remains
square.
2. Using the appropriate allen wrench supplied with your
BT3000 table saw, loosen and remove rear adjustment
screw and washer on top of rip fence.
3. Slide one of the special 5/16 in. T-nuts into top channel
of rip fence and place it between two adjustment
screws. Note: T-nuts install from rear of rip fence.
4. Replace adjustment screw and washer.
5. Tighten adjustment screw securely.
6. Check rip fence for squareness with saw blade.
TO INSTALL REMAINING T-NUTS
See Figure 3.
1. For ease of assembly, unlock rip fence and slide away
from saw blade. See Figure 3.
2. Lock rip fence.
3. Slide four remaining 5/16 in. T-nuts in top channel of rip
fence as shown in figure 3.
Note: You should now have five T-nuts in the top
channel of rip fence. Only one should be between
adjustment screws.
ASSEMBLY
ROUTER MOUNTING
ADJUSTMENT
Page 4
T-NUT SHOWN BETWEEN ADJUSTMENT SCREWS
SCREW
WASHER
RIP FENCE SHOWN
LOCKED AGAINST SAW BLADE
INSTALL T-NUTS FROM REAR OF RIP FENCE
T-NUT
Fig. 2
T-NUT
Fig. 3