Table of Contents
Advertisement
Setting Sensors using non-IP enabled Label rolls
If using non-IP-Enabled label media then there will be no sensor icons or values that show on the screen and the user must know which
type of sensor to use and where to adjust it.
If using material with no notches or black marks that fall within the specifications in chapter 10, then the gap sensor will be used and
should be adjusted with these guidelines:
1.
For label rolls that have an ODD number of labels across, set the gap sensor switch to 1
2.
For label rolls that have an EVEN number of labels across, set the gap sensor switch to 2
3.
Go into the printer display Setup > Labels > Label Sensor, and select Gap Sensor, then the green check mark
4.
Proceed to Loading the Ribbon section
5.
The printer will be operating in Standard Mode or Partial Standard Mode
If using material with notches, cut-outs or black marks that fall within the specifications in chapter 10, then the Reflect/Notch sensor will
be used and should be adjusted with these guidelines:
1.
Slide the green notch sensor left-right until the sensor eye visually aligns with the cutout, notch or black mark. You can also measure
the distance that the center of the mark or notch is in mm left of the center line of the media, then move the slider to that number.
Note: If the calibration process does not work then this alignment may need to be reexamined or fine-adjusted.
2.
Go into the printer display, Setup > Labels > Label Sensor, and select Bottom-Reflect, then the green check mark
3.
Proceed to Loading the Ribbon section
The printer will be operating in Standard Mode or Partial Standard Mode
BradyPrinter i5100
25
Hide quick links:
Advertisement
Table of Contents
