Table of Contents
Advertisement
If using a residual current circuit
■
breaker, only use one that bears the
following mark: z. The presence of
this mark is the only way to be sure
that it fulfils all the applicable
regulations.
Connect the appliance to the mains
power supply as follows:
Plug the appliance's mains plug into
1.
the designated socket.
Check that the mains plug is in
2.
securely.
Levelling the appliance
Level the appliance as follows:
Adjust the height of the appliance feet
to level the appliance. Tighten the lock
nuts on all the appliance's adjustable
feet against the housing. As you do so,
hold the foot tight and do not adjust its
height. Use the spirit level on the control
panel to check whether the appliance is
level.
Not level
Level
If the appliance is ever moved,
Note:
check that it is still level and re-level it if
necessary.
Before using the appliance for
the first time
Before you switch on the appliance:
Check that there is no visible damage to
the appliance. Do not operate the
appliance if it is damaged. Should you
have any problems, please contact your
specialist dealer or our after-sales
service.
Installing and connecting the appliance
Your appliance has been thoroughly
tested before leaving the factory. To
remove any water that may be left over
from testing, run the first wash cycle
without any laundry.
Run a program without laundry as
follows:
Press # to switch on the appliance.
1.
Set the Tub clean/Tub Clean
2.
program.
Open the appliance lid (but do not
3.
place any laundry inside).
Pull out the detergent drawer.
4.
Fill compartment I with washing
5.
power, or fill compartment II with
liquid detergent.
Close the detergent drawer.
6.
Press A.
7.
The program will start.
Switch off the appliance at the end of
8.
the program.
Your appliance is now ready to use.
en
9
Advertisement
Table of Contents
