Table of Contents
Advertisement
Operating the appliance
en
Starting a programme
Press A.
Either the programme duration or, if you
have delayed the programme start, the
Delay start/Delay Starttime, is shown in
the display.
If you want to prevent the
Note:
programme from being adjusted
inadvertently, you can activate the
childproof lock.
Childproof lock
Once the program has started, you can
lock the appliance to prevent the
functions you have set from being
changed inadvertently. To do this,
activate the childproof lock.
Activating/deactivating the child lock/
Child Lock/Child lock:
Press and hold the N wash/Wash//
Program and O Rinse buttons at the
same time for approximately 3 seconds.
The child lock/Child Lock/Child lock
indicator light changes depending on
the previous status.
Notes
If you open the lid while the
■
childproof lock is activated, a signal
will sound and the error code E3 will
be displayed. If the lid is not closed
and the A button pressed within 20
seconds, the appliance will
automatically pump water away and
display the error code CL until you
switch off the appliance.
When the childproof lock is active,
■
the appliance can be switched off
via the main switch. The childproof
lock will be deactivated when the
appliance is switched off.
22
Pausing programmes and
adding more laundry
Press A.
1.
The appliance will pause the
program.
If you need to, you can add more
2.
laundry or remove laundry.
Press A to resume the program.
3.
Notes
If you pause the appliance for more
■
than 1 hour, it will automatically
switch off.
When the wash and spin cycles are
■
in progress, make sure that you
pause the appliance before opening
the lid.
Cancelling the programme
Once the program has started, you can
cancel it at any time:
Press # to switch off the appliance.
1.
Press # to switch the appliance
2.
back on.
Open the lid and remove the laundry
3.
or start a new program.
Notes
When you start a new program, the
■
appliance will first check the current
water level and, if necessary, pump
some of the water away.
If the water level is high or there is a
■
high level of residual moisture in the
laundry, run the Spin program
before taking out your laundry.
Resuming the programme
when the programme status is
Rinse Stop
Press # to switch on the appliance.
1.
Press 0 Spin to set the Spin
2.
program and to adjust the duration
of the spin cycle.
Press A.
3.
Advertisement
Table of Contents
