Throttle Lock - Ryobi RY09973 Operator's Manual

FILLING THE TANK
WARNING:
Always stop the engine before filling the fuel tank. Never
add fuel to a machine with a running or hot engine. Move
at least 30 ft. from the refueling area before starting engine.
Do not smoke while filling the tank.
 Clean the surface around the fuel cap to prevent contami-
nation.
 Loosen the fuel cap slowly, by turning it counter-
clockwise.
 Pour the fuel mixture carefully into the tank.
 Clean and inspect the fuel cap gasket before replacing
the fuel cap.
 Replace the fuel cap and tighten it by turning it clock-
wise.
 Wipe spilled fuel from the product.
 Move at least 30 ft. away from refueling area before start-
ing the product.
WARNING:
Check for fuel leaks. If you find any leaks, correct the
problem before using the product.
WARNING:
A leaking fuel cap is a fire hazard and must be replaced
immediately.
STARTING AND STOPPING
See Figures 6 - 7.
NOTE: It is normal for smoke to be emitted from a new
engine during first use.
To start an engine that is cold or has run dry:
 Fill the fuel tank, if necessary. Always use the proper
oil/gasoline mixture. See Mixing the Fuel on page 10.
 Disengage the cruise control lever.
NOTE: Do not engage the throttle trigger during the
starting process.
 Slowly push the primer bulb seven times.
OPERATION
 Set the choke lever to the START position.
NOTE: If restarting a warm engine, leave the choke lever
in the RUN position.
 Pull the starter cord until the engine runs.
 Return the starter cord gently to the starter housing. Do
not allow the rope to snap back.
 Allow the engine to run for 15 seconds to warm up before
using.
 Engage the throttle trigger to operate.
To stop the blower:
 Release the throttle trigger.
 Press and hold the engine switch to the "O" or STOP posi-
tion.
To remove blower:
 Move harness straps off the shoulders. Let straps slide
down arms.
 Grasp the straps and lower the blower to the ground.
throttle
trigger
choke
lever
11
engine
switch
crUise control

(throttle lock)

choke
lever
stArt
Position
Fig. 6
rUn
Position
Fig. 7