Cabinet Assembly - Cornelius IMD GLACIER 500-30 Installation Manual

Countertop Icemaker IMD Glacier Series Installation Manual
Figure 13. Float Assembly
Low Water Safety Control - Adjust magnet by bending magnet arm as shown in Figure 13 to shut down unit if the
water level drops below the line on the side of the reservoir.
Bin Control - Lift the ice bin cover (Make sure ice bin cover screws are removed from the bin cover) so bin control
plate can be manually lifted until unit shuts down. Release plate and unit will restart. Replace screws.
Dispense Switch and Mechanism - By depressing the dispense lever, the dispense mechanism door on the stor-
age bin will open, and agitator will rotate counterclockwise.
NOTE: If any of these checks or adjustments cannot be achieved, refer to Troubleshooting Section of
this manual or call our Technical Support Center for assistance at 1-800-238-3600.
C A
ABINET SSEMBLY
After all the set-up and installation is completed and ensuring the unit is running and performing correctly start to
assemble the parts back.
1. Assemble back the Side Panels tightening all the (6) screws.
2. Slide back the Drip Tray to original position to assemble it with (2) screws.
3. Replace the Splash Panel & Top Cover and secure them with the (1 and 4) screws.
4. Fix the Ice chute cover back and tighten the (2) screws.
5. Replace the Ice-bin cover and tighten the (2) side screws.
6. Place the Ice Tray & Cup rest on the Drip tray from the installation kit provided.
Figure 14
Publication Number: 620068501INS - 16 - © 2018, Cornelius Inc.