Assembly Instructions - Ryobi 290r 2 Operator's Manual

INSTALL AND REMOVE THE BLOWER TUBE
WARNING:
the engine and allow the impeller to stop
before attaching or removing tubes.
WARNING:
damage to the unit, the blower tube must
be installed while operating this unit as a
blower.
Install
To install the blower tube, simply push it into the blower
housing. Push it in until the tabs on the top and bottom
of the housing slide into the blower tube detents (Fig. 1).
Remove
To remove the blower tube, use a flat blade screwdriver
to lift the tabs and pull the tube out of the blower
housing (Fig. 1).

ASSEMBLY INSTRUCTIONS

To prevent serious
personal injury, stop
To prevent serious
personal injury or
Blower
Tube
Detente
Blower
Tube
Fig. 1
Tab
7