DSC HSM2HOST8 Installation Manual page 8

H S M 2 H O S T I n s t a l l a t i o n M a n u a l
2. Press [*] to select a sub-section. A list of available options is displayed.
3. Navigate the list of options using the scroll keys or by entering a hotkey, then press [*] to select. The first programmable default is dis-
played.
4. Press [*] to select a default or to toggle it on or off.
5. Press [#] to move to the next available default. At the last default, pressing [#] returns to the previous list of options.
2.1.7 [804]>[901]-[905] Delete Wireless Devices
To delete wireless devices:
1. Enter Installer Programming section [804] then select one of the following sub-sections:
Table 2-5 Module Label Sub-Sections
Sub-Section
901 Delete wireless zone devices
902 Delete wireless key
903 Delete sirens
904 Delete repeaters
905 Delete keypads
2. Select a device to delete using the scroll keys or go directly to a specific device by entering a hotkey.
3. Press [*] to delete or [#] to exit.
2.1.8 [804]>[911]-[915] Modify Wireless Device Setup Options
To modify wireless device setup options:
1. Enter Installer Programming section [804] (Wireless Programming) then navigate to one of the following sub-sections using the scroll keys
or by entering a hotkey:
Table 2-6 Modify Wireless Device Sub-Sections
Sub-Section
911 Modify wireless zone devices
912 Modify wireless keys
913 Modify sirens
915 Modify keypads
2. Press [*] to select.
3. Choose a specific device to modify using the scroll keys or go directly to a specific device by entering a hotkey. Press [*] to select. The first
available option for the selected device is displayed.
4. Scroll to a programmable option and press [*] to select. The programming for that option is displayed.
5. Modify available device programming either by entering the hotkey or using the scroll buttons. Press [*] to accept.
6. Press [#] to move to the next configuration option. Once the last option has been reached, pressing [#] exits the programming section.
See Appendix 1: Wireless Device Configuration Options on page 20 for a complete list of available wireless configuration options.
2.1.9 [804]>[921]-[925] Replace Wireless Devices
Use this option to replace a faulty device enrolled on the system with another device of the same type while maintaining the configuration of the
original. The faulty device does not need to be deleted.
To replace a wireless device:
1. Enter Installer Programming section [804] then select one of the following sub-sections:
Table 2-7 Replace Device Sub-Sections
Sub-Section
921 Replace wireless zone devices
922 Replace wireless keys
923 Replace sirens
924 Replace repeater
925 Replace keypad
2. Press [*] to select a sub-section. The first available device is displayed.
3. Select a device to replace using the scroll keys or go directly to a specific device by entering a hotkey.
4. Press [*]. When prompted, activate the device (full enrollment) or enter the device ID (pre-enrollment). A message is displayed confirming
enrollment.
Description
Description
Description
W i r e l e s s D e v i c e S e t u p a n d P r o g r a m m i n g
6