Table of Contents
Advertisement
2
1
1 Mounting Screws and Ears
2 Cable
© National Instruments Corporation
To connect the TBX-1316 to an SCXI module front connector, perform the
following steps:
1.
If you have not already installed the E/M Series DAQ device, refer to
the DAQ Quick Start Guide for installation instructions.
2.
If you have not already installed the SCXI module, refer to the
SCXI Quick Start Guide for installation instructions.
3.
Power off the SCXI chassis.
4.
Do one of the following:
•
Power off the computer that contains the E/M Series DAQ device,
and disconnect the device from the chassis.
•
Power off the PXI portion of the PXI/SCXI combination chassis,
and if used, remove the cable connecting the SCXI portion of the
chassis to E/M Series device.
5.
Connect the TBX cable adapter to the appropriate SCXI module, and
secure it by tightening both thumbscrews, as shown in Figure 4.
4
3
5
4
3
2
1
5
3
3 Thumbscrews
4 SCXI Chassis
Figure 4. Connecting the Cable to the SCXI Module
5 TBX Cable Adapter
9
TBX-1316 High-Voltage Attenuator Terminal Block
Advertisement
Table of Contents
