National Instruments TBX-1316 Installation Manual page 13

High-voltage attenuator terminal block

Table of Contents

If your application cable diameter is smaller than what is listed above, replace the

Note

supplied strain reliefs with the following strain reliefs or their equivalents. These strain

reliefs are not supplied with the TBX-1316.

Environmental

Safety

For UL and other safety certifications, refer to the product label, or visit

Note

ni.com/certification

appropriate link in the Certification column.

Strain-relief cable diameter .................... 5 to 9 mm signals

Strain reliefs available............................ 8 signals

Field wire

Diameter.......................................... 6 to 20 AWG

Temperature rating.......................... 90 °C

Connector type ....................................... Screw terminal

Operating temperature............................ 0 to 55 °C

Storage temperature ............................... –20 to 70 °C

Humidity ................................................ 10 to 90% RH, noncondensing

Maximum altitude .................................. 2,000 m

Pollution Degree

(indoor use only) .................................... 2

The TBX-1316 is designed to meet the requirements of the following

standards of safety for electrical equipment for measurement, control,

and laboratory use:

•

IEC 61010-1, EN 61010-1

•

UL 61010-1

•

CAN/CSA-C22.2 No. 61010-1

, search by model number or product line, and click the

(0.197 to 0.354 in.)

SKINTOP # S2213

2 to 6 mm PE ground

(0.079 to 0.236 in.)

SKINTOP # S2209

1 PE ground

TBX-1316 High-Voltage Attenuator Terminal Block

Table of Contents