Table of Contents
Advertisement
Calibrating the TBX-1316
© National Instruments Corporation
7.
Connect the other end of the cable assembly to the SCXI module front
connector, and secure the cable by tightening the mounting screws.
Figure 6 shows the completed installation.
8.
If necessary, reconnect the E/M Series DAQ device to the chassis.
9.
Refer to the SCXI Quick Start Guide to power on the SCXI chassis and
configure the system in software.
NI recommends you perform an external calibration once a year.
You can download all available external calibration documents from
ni.com/calibration
5
4
3
2
1
Figure 6. Completed Installation
by clicking Manual Calibration Procedures.
11
TBX-1316 High-Voltage Attenuator Terminal Block
Advertisement
Table of Contents
