Russound CAV6.6-S2 Instruction Manual page 60

INSTALLER
INSTALLATION MENU
Numeric IR (cont'd)
i. MACRO -
(Macro)
ii. MACRO ID –
(MacID)
e. All Other Selections:
11. DEVICE CODE –
(DevCd)
12. KEY FUNCTION –
(KeyFn)
13. SAVE CHANGES? –
(Save?)
SRC SEL CMD (SrcSC)
This procedure permits a command to be sent to the source component when the source component
is initially selected. See Source Setup Menu on Page 55 and Source Select Command & # Of
Sources - Flow Chart on page 71
1. SOURCE NUM –
(Src #)
2. COMMAND TYPE –
(CmdTp)
a. Selected: Learned IR
i. LEARNED SRC –
(LnSrc)
b. Selected: Unassigned
c. Selected: Default
d. Selected: Macro:
i. MACRO -
(Macro)
ii. MACRO ID –
(MacID)
60
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number. Menu advances to SAVE CHANGES
(step 13)
Procedure advances to DEVICE CODE (step 11)
Source component code for IR control.
Select a function (Enter, Play, etc.).
Select "yes" to save the changes.
Select the source number this command will be configured for.
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
(LrnIR) not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 4)
The source select command is cleared. Procedure advances to
(Unasg) SAVE CHANGES (step 5)
Default selects the same device type and device code previously
(Deflt) setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 4)
(To build macros, see Macro Editor page 65)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number. Menu advances to SAVE CHANGES
(step 5)