Troubleshooting - Bissell CLEANVIE PROHEAT 46L5-F User Manual

Troubleshooting

Problem
Heat indicator
light does not
illuminate
Reduced
spray OR
no spray
DirtLifter
PowerBrush
does not turn
Cleaner
not picking
up solution
Please do
not return
this product
to the store.
www.BISSELL.com
16
Possible causes
The heater switch is not turned on.
The machine power switch is not
turned on.
Bladder may be empty.
2-in-1 water tank may not be seat-
ed properly.
Pump may have lost prime.
Pump belt may be broken.
The brush belt or pump belt is off
or broken.
ReadyTools dial may be on the
wrong setting for the cleaning job.
Poor tool position. (Hand held
attachments only).
Removable nozzle may not be
properly attached.
2-in-1 water tank lid is not properly
installed.
2-in-1 water tank is not properly
seated.
2-in-1 water tank has picked up
maximum dirty water.
The lint screen may be clogged.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Turn on the heater switch located on
side of unit.
Both switches must be on to activate
the heat indicator light.
Turn power switch off; refill bladder
with clean hand hot tap water and
formula.
Turn power switch off; remove tank
and reseat.
Turn power switch off; after 1 minute
turn on and depress spray trigger.
Press power pedal
from outlet. Follow pump belt removal
& replacement instructions on page 15.
Press power pedal
from outlet. Follow brush and
pump belt removal & replacement
instructions on pages 14 and 15.
Set ReadyTools dial to either FLOOR
CLEANING or TOOLS.
Adjust angle; apply more downward
pressure.
Make sure nozzle is on correctly by
slightly raising front of machine to line
up slots on the base of the machine
with the hooks on nozzle. Attach at
base first and then click nozzle into
place. Refer to image 5 on page 9.
Re-install lid; refer to image 5 on
page 8.
2-in-1 water tank must be firmly
seated to function; remove and reseat
2-in-1 water tank.
Empty 2-in-1 water tank and refill, refer
to the Operation section.
Clean out lint screen. Refer to page 9.
off and unplug
and unplug