Maintenance & Care - Bissell CLEANVIE PROHEAT 46L5-F User Manual

Maintenance & Care
Machine care
For best results, a few simple steps can assure
your machine is well maintained after cleaning is
complete.
1. Flush your machine of any remaining
residual solution.
a. Fill the 2-in-1 clean water tank
(bladder) with clean hot tap water.
b. Plug your machine into a proper outlet
and set the ReadyTools dial to the "FLOOR
CLEANING" setting. Turn the power on by
pressing the power button.
c. Recline the handle and press the spray
trigger for 15 seconds while making forward
and backward passes on carpet. Release the
trigger to suction. Repeat for another 15 sec-
onds. Continue without pressing the trigger
until there is no more water being suctioned.
2. Turn power switch off. Unplug the machine
and wrap the power cord.
3. After emptying the 2-in-1 water tank, rinse
with running hot tap water, taking care to clean
underneath and around the heavy duty bladder.
Clean out red lint screen (located on tank lid).
Removable nozzle may be rinsed if necessary.
4. Before you place the 2-in-1 water tank back
onto the machine, remove the red solution filter
cap (on the base of the machine). Remove the
cap by inserting a coin or a flat head screwdriver
into the slot on the top. Turn counter clockwise
to unscrew.
5. a . Remove the white filter by grasping the
post and pulling up and out of the unit.
Rinse the filter under cold water.
NOTE: Be careful not to drop the filter into
the sink or disposal.
b . Replace the white filter back into the filter
area. NOTE: Make sure the white
filter is seated properly before replacing
the red solution filter cap.
c . Replace the red solution filter cap
and turn clockwise to tighten.
www.BISSELL.com
12
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
4.
5a.