External input signal cable
The external input signal cable is not prepared as an option. Fabricate the cable on the customer side.
The connection diagram differs depending on the type of the manual pulse generator/incremental synchronous encoder to be
used and the connected power supply.
Make the cable as shown in the following connection diagram.
When using the external power supplly (Recommended)
Simple Motion module
side
(1A_ _, 1B_ _ )
(2A_ _, 2B_ _ )
Solderless terminal
FG wire
FG wire
(1) Manual pulse generator/Incremental
synchronous encoder
(2) Forced stop input/external
input signal
(3) External input signal
Appendix 3 Connection with External Devices of the RD77MS
A
APPX
97