PMX-8700 8 Channel / 4 Bus Powered Console Mixer Congratulations on your choice of the NADY AUDIO PMX-8700 powered console mixer — you have purchased one of the finest powered mixing units on the market today. This unit was developed using the expertise of professional sound engineers and working musicians.
WA R N I N G IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.).
Parts of the unit can become very warm during use. This is normal during operation. Care should be taken to ensure that there is enough space around the unit for cooling. Also, do not place the PMX-8700 powered mixer on high temperature devices such as power amplifiers, etc., or the unit may overheat in operation.
C O N T R O L S A N D C O N N E C T I O N S 1. CHANNEL SECTION (1) INPUTS The electronically balanced XLR and 1/4” TRS inputs are designed to accept signals from any balanced or unbalanced low impedance (Low Z) microphone or line level source such as those from keyboards, drum machines, or samplers.
+/-15dB of attenuation at 2.8 KHz. Master bus. These can be used to return effected signals into the PMX-8700 powered mixer or they can be used as auxiliary inputs [Note: Always reset a channel’s input Trim Control (3) (or from line level devices such as keyboards or Tape Returns of external device’s output level) after altering the amount of...
Page 7
C O N T R O L S A N D C O N N E C T I O N S (15) (16) (14) (14) HEADPHONE LED DISPLAY SELECT BUTTONS These buttons determine which output signals are sent to the Headphones and LED Level Meters.
(24) (27) (25) (29) POWER ON/OFF SWITCH Use this switch to turn ON & OFF the PMX-8700. (24) AUX SEND 1 & 2 OUTPUTS These mono unbalanced 1/4” jacks output the auxiliary signals (30) PHANTOM POWER SWITCH which can be adjusted by the Aux Send 1 & 2 Volume Faders This switch enables or disables global 48VDC Phantom Power (21).
S P E C I F I C AT I O N S 1. INPUT SECTION Input Connector Impedance Max Level Sensitivity CHANNEL 1-6 (set to MIC) 1/4” TRS & XLR BALANCED 3.2KΩ +10dBm, 3.5V RMS* -65dBm** CHANNEL 1-6 (set to MIC) 1/4”...
Page 12
(U.S.) Should your NADY AUDIO product require service, please contact the Nady Service Department via telephone at (510) 652-2411, or e-mail at service@nady.com. (International) For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased this product.