Problem At Starting Os - NEC Express5800/R110i-1 Maintenance Manual

Chapter 1 Maintenance
[?] When Starter Pack is installed to Windows Server 2008 R2, the below message is sometimes displayed for
a moment upon shutdown
1 program still needs to close:
(Waiting for) Task Host Window

No problems for system operation.
For details, refer to the website below:
https://support.microsoft.com/en-us/help/975777
[?] Windows was installed as "Workgroup" although it is set to "Join the Domain"
 Is the LAN cable properly connected?

If the LAN cable is not connected, Windows is installed in workgroup setting. You can change the setting
by Control Panel on installed Windows.
[?] The Telnet Service is not installed

Install the telnet service according to the following procedure.
(1) Adjust the computer name to 14 characters or less.
(2) Click Run on Start menu.
(3) Type tlntsvr/service in the Open box, and then click OK.
(4) Click Start menu, point to Control Panel, click Administrative Tools, and then click Services to
confirm whether the Telnet Service is registered.
(5) You can specify the computer name with 15 characters or more after installing the telnet service.
[?] An error message is displayed at the system reboot after installing the graphics accelerator driver
 Is your system environment Server Core of Windows Server 2012 R2?

An application error is registered in the event viewer, but this does not affect the system.
5.4

Problem at Starting OS

[?] Unable to start OS
 Has the BIOS configuration of the RAID controller changed?

Set the correct BIOS configuration with a RAID Configuration Utility (LSI Software RAID Configuration
Utility, Off-line Utility).
 Is the RAID controller detected by POST?

Turn on the power after the RAID controller is detected as being connected successfully.
 Is the RAID controller inserted firmly straight into the PCI slot?

Install the RAID controller properly.
 Is the PCI slot able to install the RAID controller?

Check the restrictions of PCI slots on the server and then install the RAID controller to the correct slot.
 Are hard disk drives properly installed?

Install the hard disk drive to the RAID controller properly.
 Is SAS cable connected to hard disk drive correctly?

Connect the SAS cable properly.
Express5800/R110i-1, T110i-S, T110i Maintenance Guide
5. Troubleshooting
33