Problem Of Starting Os - NEC Express5800/R310e-E4 Maintenance Manual

Chapter 1 Maintenance
[?] DISK ACCESS LED is blinking in amber:

Did you properly setup the duplex of HDDs?
 For details about the indication, see Chapter 1 (6.1 Error Indication by LED).
See Chapter 2 (1. Hard Disk Drive Operations), and set up the duplex of HDDs.
[?] During setting up, Error or Warning logs are recorded in System and Applications Event Log:
 Ignore the logs during setting up.
8.4

Problem of Starting OS

[?] Unable to start OS:

Are hard disk drives properly installed?
 Install hard disk drives properly.

Is the internal SAS cable connected to hard disk drive correctly?
 Connect the SAS cable properly.

Is the EXPRESSBUILDER DVD inserted?
 Eject the EXPRESSBUILDER DVD and retry.

Is a Flash FDD connected to the server?
 Take out the Flash FDD and restart the server.
[?] The server repeats rebooting at startup:

Is CHKDSK run at startup?
 Change to Disabled in the following BIOS setting by using BIOS Setup Utility.
Server - OS Boot Monitoring
For details, see Chapter 3 (1. System BIOS).
* After completion of CHKDSK, restart the server and change the above setting back to
Enabled.
CHKDSK is run in the following conditions:
– CHKDSK is scheduled to be run at next startup.
– Corruption of file system is detected since the previous startup until shutdown.
– Inconsistency (corruption) of file system is detected while mounting at startup.

Is the setting of OS Boot Monitoring appropriate?
 Change the setting of OS Boot Monitoring to suit your system environment. See Chapter 3 (1.
System BIOS) for details.
Express5800/R310e-E4, R320e-E4, R320e-M4, R310f-E4, R320f-E4, R320f-M4 Maintenance Guide (Windows)
92
8. Troubleshooting