Operating Procedures For Configuration Utility In The Legacy Mode; Create/Add Configuration - NEC Express5800/R110i-1 Maintenance Manual

Chapter 2 Useful Features
5.3
Operating Procedures for Configuration Utility in the Legacy
Mode
5.3.1

Create/Add Configuration

1. Run LSI Software RAID Configuration Utility.
2. From the TOP menu (Management Menu), select Configure, and then New Configuration.
To add settings to an existing configuration, select View/add Configuration.
Run LSI Software RAID Configuration Utility
Create configuration information
(Virtual Drive settings)
Check the Virtual Drive settings
Initialize Virtual Drive
Perform Consistency Check
Exit LSI Software RAID Configuration Utility
Creating a configuration by using "New Configuration" clears the existing
Important
configuration. To add configuration to the existing configuration, select
"View/add Configuration".

Note You cannot specify the Virtual Drive capacity on the Easy Configuration
menu. Use
New Configuration or View/Add Configuration instead.

For RAID10, the Virtual Drive is configured with the maximum capacity. You
cannot specify the capacity.

For RAID0, you can skip the step for checking the consistency.
Express5800/R110i-1, T110i-S, T110i Maintenance Guide
5. RAID System Configuration
129