Operating Mode Selection; Fan Operation - Lennox ComfortSense 7500 User Manual

Operating Mode Selection

Touch anywhere in the area indicated below to se-
lect how the system will operate.
2:31 am
78
inside
away
Figure 3. Operating Mode Selection
Select Modes
1. HEAT/COOL allows the thermostat to switch
between heating and cooling automatically.
2. HEAT ONLY allows only heating demand.
3. COOL ONLY allows only cooling demand.
4. OFF indicates system has been turned off.
5. EMERGENCY HEAT allows heat pump system
to use a secondary heat source to come on
and reach the desired user temperature setting
faster.
heat−to
57%
0
cool−to
78°
outside
schedule 1
69°
6. SCHEDULES (1, 2 or 3) See Edit Schedules on
page 13 for customizing schedules).
7. ON, AUTO and CIRCULATE - Select by
touching the desired fan operation ON, AUTO
and CIRCULATE. When selected a green check
mark will be indicated.
If FAN mode AUTO, ON or CIRCULATE is selected
during scheduling for the current period, the ther-
mostat will indicate the current fan mode in the in-
formation display (FAN ON or FAN CIRC). In the
CIRCULATE mode, the fan will follow the setting
72°
configured under menu > settings > fan >select
fan mode. Under circulate the circulate off time can
be set from 1 to 30 minutes.
F O
an peratiOn
The desired fan mode can be selected in addition to
selected mode of operation.
Icon
6
Table 2. Fan Operation
Mode Description
Fan is NOT following
schedule and runs continu-
on
ously until it is changed from
the select mode.
Fan will follow the fan setting
auto
in the selected schedule.
the