Table of Contents
Advertisement
2. PICTURE menu
FUNCTION
Picture Mode
Reference
Mode
Brightness
Contrast
Color
Tint
Sharpness
Brilliant Color
Operation
56
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See
picture mode" on page 33
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See
details.
Adjusts the brightness of the image. See
34
for details.
Adjusts the degree of difference between dark and light in the image.
See"Adjusting Contrast" on page 34
Adjusts the color saturation level -- the amount of each color in a video
image. See
"Adjusting Color" on page 34
This function is only available when a Video, S-Video or YPbPr
signal is selected.
Adjusts the red and green color tones of the image. See
on page 34
for details.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC, NTSC443 or SECAM.
Adjusts the sharpness of the image. See
34
for details.
This function is only available when a Video, S-Video or YPbPr
signal is selected.
Adjusts the image to make it look sharper or softer. See
Brilliant Color" on page 34
DESCRIPTION
for details.
"Setting the User 1/User 2 mode" on page 33
"Adjusting Brightness" on page
for details.
for details.
"Adjusting Sharpness" on page
for details.
"Selecting a
for
"Adjusting Tint"
"Adjusting
Advertisement
Table of Contents
