Yamaha DTX402K Owner's Manual page 17

Step 5
Rotating the pads into place
For DTX402K and DTX432K
Step 5 applies to each of the four pads.
For DTX452K
Step 5 applies to each of the three tom pads. For adjusting the snare pad, see

1.
Loosen the key bolt on each of the pads.
2.
Rotate the pads to positions where they will be easy to play. (If necessary, refer to the picture of the properly assembled kit
on page 12.)
NOTE
For the snare pad, you can also adjust the angle of the joint which supports the snare pad by loosening the s key bolt.
3.
Tighten each of the key bolts to secure the pads in place.
Step 6
Attaching the hi-hat holder
Hi-hat holder

1.
Loosen the two key bolts in the back of the snare part.
2.
Insert the hi-hat holder into the back of the snare part as shown in the figure.
The hi-hat holder and the other two cymbal holders seem similar, but are actually different.
Only the hi-hat holder has a washer and stopper.
•
When correctly inserted, the tip of the hi-hat holder will protrude slightly from the bottom of the snare part.
•
When correctly oriented, the hi-hat holder will be horizontal to the snare part as shown in the Top view.

3.
Tighten the two key bolts to secure the hi-hat holder.
Step 4
Snare pad
Washer
Top view
Stopper
DTX402K DTX432K DTX452K Owner's Manual
Assembly Guide
.
Setup
15