JUKI AMB-289 Engineer's Manual page 112

No.
Head type
1 : Standard
2 to 9 : Unused
Each time origin retrieval
1 : Bottom feed only
2 : Bottom feed + needle rocking
3 : Bottom feed + thread drawing
4 : Bottom feed + needle rocking + thread drawing
* Origin retrieval of bottom feed is performed only at the time
of sewing flat/wrapped-around button with blindstitch.
Button loader lifting amount
Lifting amount after grasping button
is set.
Height from tongue stopper lower plate
Set this item when tongue stopper
parts are changed.
Tongue change display mode
When READY key is pressed, whether AMB-189
type tongue or AMB-289 type one is judged, and
displays below are shown.
* Judge value is determined with
: Without display
: When tongue change is necessary
: When AMB-189 type tongue (wide
gauge) is used
: When AMB-289 type tongue
(narrow gauge) is used
: Tongue type used is displayed
each time.
Tongue change blindstitch width
Blindstich width which is the
standard to make the check screen
display.
Pedal type
Kind of pedal to be used is set.
: Standerd pedal
: PK-47
*1 Data that have been memorized in the machine head EEP-ROM, and the adjustment value has been
written at the time of delivery.
Item
.
− 108
Setting range Edit unit
1 to 9
1
1 to 4
1
5.0 to 10.0
0.1mm
0 to 8.0
0.1mm
– – –
– – –
1.0 to 20.0 0.1mm
– – –
– – –
−
Initial display Remarks
*1
1
1
6.5
*1
5.6
When tongue
change is
necessary
1.6
Standerd
pedal