JUKI AMB-289 Engineer's Manual page 111

No.
Operation speed setting
Motion speed of the feed motor by means of pedal
operation is set.
1 : Slow
10 : Fast
Bottom feed move amount at the time of manual
mode
As much as the move amount of the
bottom feed motor to which cloth
setting position is set is advanced.
Position of the cloth presser at the time of manual
mode
: Up
: Down
2) Level 2
Memory switch data (level 2) can be edited when pressing MODE switch for as long as 6 seconds.
No.
VCM control starting angle offset
Tongue lifting amount
Thread trimming control mode
: Thread trimming priority mode
: Cycle time priority mode
Button loader inserting height
compensation
Max. value of blindstitch width
setting
Bottom feed position of rear hole
of blindstitch
Bottom feed position from origin at
the rear hole of blindstitch is set.
Head tilt sensor detection ON/OFF
: OFF
*1 Data that have been memorized in the machine head EEP-ROM, and the adjustment value has been
written at the time of delivery.
Item
Item
: ON
− 107
Setting range Edit unit
1 to 10 1
0 to 25.0 0.1mm
– – – – – –
Setting range Edit unit
1˚
– 20 to 20.0
10.0 to 24.0 0.1mm
– – – – – –
10.0 to 25.0 0.1mm
0.2mm
0.0 to 6.0
0.0 to 2.0 0.1mm
– – – – – –
−
Initial display Remarks
10.0
10.0
Up
Initial display Remarks
*1
0
16.5mm *1
Thread trimming
priority mode
17.0
1.6
1.5
ON