Backrest; Backrest Cover - Invacare Esprit Action 4 NG User Manual

Invacare® Esprit Action® 4 NG
4. Two depth positions G are possible, frontwards or
backwards.
5. Perform the setting on both sides, if necessary.
Adjusting the armpad height
1. Loosen the screw B with 5 mm Allen key at top of the
armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw B in
place.
3. Tighten the screw B (5–6 Nm).
4. Perform the setting on both sides.
Adjusting the armpad depth
1. Loosen the 2 screws C below the armpad bracket.
2. Move the armpad frontwards or rearwards until you
reach the desired depth, while keeping screw C in
place.
3. Tighten the 2 screws C (1,5–2 Nm).
4. Perform the setting on both sides.
Adjusting the side protection height
1. Loosen the 2 screws of the side protection clamps E.
2. Move the side protection upwards or downwards until
you reach the desired height.
3. Tighten the 2 screws of the side protect clamps E
(0,7–1,2 Nm).
4. Perform the setting on both sides.

3.6 Backrest

There are three types of backrest (Fixed, Folding and
Reclining) available.
24

3.6.1 Backrest cover

You can adjust the tension of the backrest cover as required.
Adjusting the backrest cover
1. Remove the backrest cushion A.
2. Loosen the Velcro® tapes B on the rear of the backrest
cover by simply pulling on them.
3. Tighten or loosen the tapes as required then reattach
them.
WARNING!
Risk of tipping
If the bands are set very loose, the tipping point
of your wheelchair is changed for the worse.
– Ensure that the bands are set correctly.
IMPORTANT!
– Do not overtighten the bands; this is to ensure
that the geometry of the wheelchair is not
changed.
1640502-B