Control Units Information; Control Unit Adjustments - Invacare Esprit Action 4 NG User Manual

Invacare® Esprit Action® 4 NG
Initial setup should always be done by a healthcare
professional. Adjustment by the user is only
recommended after they have been given
appropriate guidance by the healthcare professional.
Electrical adjustment options
Refer to Control unit chapter, ALBER esprit user
manual, for your control unit on operating electrical
adjustment options. In any case, contact your
authorized dealer.

3.3 Control units information

Your mobility device may be fitted with one of several
different control units. For information on the different
functions and how to operate a particular control unit, refer
to Control unit and Control unit for attendants chapters,
ALBER esprit user manual.

3.4 Control unit adjustments

CAUTION!
Risk of injury
When leaning on the control unit, for example,
when transferring into or out of the wheelchair,
the control unit holder may break and the user
may fall out of the chair.
– Never lean on the control unit as a support for,
for example, transfer.
22
CAUTION!
Risk of the control unit being pushed backwards
during an accidental collision with an obstacle,
such as a doorframe or table, and the joystick
being jammed against the armpad if the position
of the control unit is adjusted and all screws are
not completely tightened
This will cause the mobility device to drive
forward uncontrollably and potentially injure the
mobility device user and any person standing in
the way.
– When adjusting the position of the control unit,
always make sure to tighten all screws securely.
– If this should accidentally happen, immediately
switch the mobility device electronics OFF at
the control unit.
Adjusting the length
1. Loosen wing screw A or/and lever B.
2. Shift the control unit forwards or backwards to the
desired distance.
3. Retighten the wing screw A or/and lever B .
1640502-B