Table of Contents
Advertisement
4-4-3 CARTRIDGE
1. In the service mode, press the Setup button until
CARTRIDGE is displayed.
2. Press the Start button when the CHANGE CRT
operation menu is displayed.
4-4-3-1 Change Cartridge
Allows you to change the cartridge. For information
on replacing the cartridge, refer to the User's Guide.
Notes:
• You must install the color cartridge into the left
holder, the black (or photo) cartridge into the right
holder.
• When you inset a new cartridge, push the
cartridge until it snaps in place.
• After replacing the cartridge, you must align the
cartridge.
4-4-3-2 Align Cartridge
Allows you to adjust the alignment of the cartridge
nozzles. For information on aligning the cartridges,
refer to the User's Guide.
Note: If you do not align the cartridge, the
characters or lines in the document may be printed
crookedly.
4-4-3-3 Clean Cartridge
Allows you to clean the print nozzles on the
cartridge. For information on cleaning the
cartridges, refer to the User's Guide.
Note: If the print is light or not clear, clean the
cartridge two or three times.
4-4-4 NVRAM TEST
1. In the service mode, press the Setup button until
NVRAM TEST is displayed.
2. Press the Start button, and the NVRAM test list
prints.
Samsung Electronics
4-4-5 Download
1. In the service mode, press the Setup button until
DOWNLOAD is displayed.
2. Press the Start button, and the printer goes into
the downloading mode.
3. To download the ROM file from the PC
connected to the printer using the parallel cable
(IEEE 1284), type in the DOS prompt: COPY /b
SCX1000S LPT1 (where SCX1000S is the ROM
file.)
4. When downloading is successfully completed,
the printer returns to the idle mode.
Notes:
• After Download, you must clear the memory.
• To enter the 'Memory clear',power 'off' and 'on'
and then press the 'Stop' button untill 'memory
clearing' is displayed in LCD.
Troubleshooting
4-9
Advertisement
Table of Contents
