Disassembly and Reassembly
3-8 Drive PBA
1. Before you disassemble the drive PBA, you
should remove:
* Rear cover. (See page 3-1)
2. Unlatch the drive PBA, then pull it toward you.
3-9 SMPS
1. Before you disassemble the SMPS, you should
remove:
* Rear cover. (See page 3-1)
2. Unlatch the Drive PBA, then pull it toward you.
3-8
Push the locker
to unlatch the
board.
Push the locker to unlatch
the board.
3. Remove one ground screw and unplug all
connectors, then remove the drive PBA.
3. Remove one connector, then remove the SMPS.
Samsung Electronics