Using The Timer; Using The Remote Control - Prem-I-Air EH0533 Manual

UP and DOWN buttons:
Use the UP and DOWN buttons to select the desired room
temperature. The temperature can be set to any temperature from
16 °C to 31 °C. Selecting a lower temperature whilst heating, or a
higher temperature whilst cooling will reduce power consumption.
When either TEMP button is pressed, the display will show the set
temperature for 5 seconds, then will revert to showing the room
temperature.

USING THE TIMER

The timer can set the appliance to run for a selected time (between
1 and 24 hours) and then turn OFF.
Or, it can set the appliance to wait for a selected time (between 1
and 24 hours) before turning ON.
To select timed turn-off press the timer button until the yellow
indicator is illuminated. Then adjust the time using the UP and
DOWN for the number of hours delay before switching off.
To select timed turn-on, press the ON/OFF button to put the
appliance into STAND-BY. Then press the TIMER button until the
yellow indicator is illuminated. Then adjust the time using the UP
and DOWN buttons for the number of hours delay before
switching on.
To cancel the timer, press either TIMER button again.

USING THE REMOTE CONTROL

The heating, cooling, dehumidifying and fan modes are selected in
exactly the same way as using the control panel on the main unit.
Using the timer
To program the time at which the appliance will switch off, press
the TIMER button until is displayed. Then set the time at
which it is required to turn off, using the HR and MIN buttons.
To select the time at which the appliance will switch on, press the
TIMER button until is displayed. Then set the time at which
it is required to turn on, using the HR and MIN buttons.
Sleep Mode
When cooling, sleep mode increases the temperature by 1°C per
Page 9