Maintenance - Prem-I-Air EH0533 Manual

Indoor climate control, 2.8 kw of cooling, 2.9 kw of heating air conditioning efficient heating (air-source heat-pump) cooling remote control suitable for low-wall installation no external unit required 3 fan speeds
Table of Contents

Advertisement

Before cleaning, turn the appliance off using the button on the
control panel (NEVER switch off the power at the mains socket
whilst the appliance is running). Wait until the appliance stops and
then disconnect from the mains supply. The case may then be
cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do no use stronger
detergents or solvents as these may damage the plastic.
Using a dry 25 mm paint-brush, remove any dust from the grilles.
using without the filter may lead to a build-up of a dust on the heat
exchangers, which may constitute a fire hazard.
If the mains lead is damaged, it must be replaced by the
manufacturer or an authorised service centre. If the mains plug
needs to be replaced, proceed as follows:
sheath of the cable) and it fully tightened.

MAINTENANCE

Every two weeks, clean the air
• Connect the brown wire to the
terminal labelled "L".
• Connect the blue wire to the
terminal labelled "N".
• Connect the green/yellow wire to
the terminal labelled with the earth
symbol or "E".
• Make sure that the cord-grip is
positioned correctly (over the outer
Page 11
filter − the filter is located at
the back of the appliance
towards the top. Remove the
filter, and wash with hand-hot
water
with
detergent.
Dry
before replacing.
Using the appliance with a
blocked filter will severely
reduce its efficiency, and
a
drop
of
thoroughly

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents