Summary of Contents for Prem-I-Air EH0533
- Page 1 EH0533 Indoor Climate Control 2.8 kW of cooling, 2.9 kW of heating Air Conditioning Efficient heating (air-source heat-pump) Cooling Remote control Suitable for low-wall installation No external unit required 3 Fan speeds Page 1...
-
Page 2: Before Use
IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. BEFORE USE Inspect the product including its cable and plug for any signs of damage. If the product is damaged, DO NOT use it, and contact your supplier immediately. -
Page 3: Installation
INSTALLATION Parts description: 1. Air Outlet 2. LED Display 3. Remote control storage 4. Control Panel 5. Handles 6. Dust Filter 7. Hanging holes 8. Connector for optional wired remote control 9. Air Exhaust 10. Air inlet 11. Drainage hole The appliance weighs 32.5 kg. - Page 4 A. Attach the template to the wall using masking tape. Use a spirit level to ensure that it is perfectly level. B. Drill the fixing holes shown in black, and insert wall plugs. C. Using a 135 mm core drill, drill the two air intake holes. These should be drilled with a downwards slope of between 3°...
- Page 5 the wall using the screws provided, then fit the drainage tube into the 30 mm hole and seal with foam as above. If the outside of the wall is not accessible, proceed as follows. 1. Attach the nylon cords to the rubber ring as shown. 2.
-
Page 6: Pat Testing
does not engage properly with the drain tube in the wall, leakage will occur. L. If the mains lead is fitted with a Schuko plug (with two round pins), either fit the 13 A plug adaptor provided, or remove the Schuko plug and fit a 13 A plug. -
Page 7: Product Safety
PRODUCT SAFETY • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. -
Page 8: Operation
OPERATION Plug the mains lead into a 13 Amp mains socket (unless permanently installed) If connecting via an extension lead, make sure that the lead is rated at 13 Amps or more, and that it is fully unwound. Switch the appliance on at the mains socket. Press the ON/OFF button to start the appliance. -
Page 9: Using The Timer
UP and DOWN buttons: Use the UP and DOWN buttons to select the desired room temperature. The temperature can be set to any temperature from 16 °C to 31 °C. Selecting a lower temperature whilst heating, or a higher temperature whilst cooling will reduce power consumption. When either TEMP button is pressed, the display will show the set temperature for 5 seconds, then will revert to showing the room temperature. - Page 10 hour for the first two hours, then maintains the temperature 2°C above the set temperature for the next six hours. The fan runs at the lowest speed. When heating, sleep mode decreases the temperature by 1°C per hour for the first two hours, then maintains the temperature 2°C below the set temperature for the next six hours.
-
Page 11: Maintenance
MAINTENANCE Before cleaning, turn the appliance off using the button on the control panel (NEVER switch off the power at the mains socket whilst the appliance is running). Wait until the appliance stops and then disconnect from the mains supply. The case may then be cleaned using a damp cloth with a drop of washing-up liquid to remove any dust or dirt from the case. -
Page 12: Disposal And Recycling
DISPOSAL AND RECYCLING You must not dispose of this appliance with domestic household waste. Most local authorities have specific collection system for appliances and disposal is free of charge to the end-user. When replacing an existing appliance with a similar new appliance your retailer may take the old appliance for disposal. -
Page 13: Fault Codes
• Remote control does not work: Check batteries are correctly installed, and are not exhausted. Make sure that the remote control is pointed towards the main unit when being used. • Water leakage Drain hole slopes the wrong way Drain tube not fitted correctly •... -
Page 14: Technical Specification
TECHNICAL SPECIFICATION Dimensions: 465×765×235 mm Weight: 32.5 kg Cooling capacity: 2800 W (9500 BTU/hour) Heating capacity (heat pump): 2900 W (10000 BTU/hour) Heating capacity (resistance heater): 1200 W Power supply: 230 V ~ Power consumption (cooling): 1050 W Power consumption (heat pump): 1080 W Power consumption (resistance heater): 1200 W... -
Page 15: Service / Warranty
SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of twelve months. Should this appliance be operated under conditions other than those recommended, at voltages other than the voltage indicated on the appliance, or any attempts made to service or modify the appliance, then the warranty will be rendered void.