Operation - Prem-I-Air EH0533 Manual

Plug the mains lead into a 13 Amp mains socket (unless
permanently installed)
If connecting via an extension lead, make sure that the lead is
rated at 13 Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
Press the ON/OFF button to start the appliance. The appliance will
start to operate after a delay of about a minute.
Always use the ON/OFF button to start and stop the
appliance. Do not switch off at the mains socket whilst it is
running because this will reduce the life of the compressor.
Select the mode by pressing the "MODE" button: The LED display
on the mains unit displays the two-letter code shown. The available
modes are:
AU
Automatic mode: either heats or cools as required to maintain
the room temperature between 20 °C and 25 °C. The UP and
DOWN buttons are inoperative in AUTO mode.
CO
Cooling mode: cools if the room temperature is above the
selected temperature. Then use the UP and DOWN buttons to
select the desired room temperature. When the temperature
reaches the desired temperature, the compressor will stop, and the
fan will continue to run.
dE
Dehumidifying mode: removes humidity, but does not affect
room temperature. The fan operates at its lowest speed.
FA
Fan mode: circulates the air, but does not affect room
temperature or humidity.
HE
Heating mode: heats if the room is temperature is below the
selected temperature. Then use the UP and DOWN buttons to
select the desired room temperature. When the temperature
reaches the desired temperature, the compressor will stop, and the
fan will continue to run. Below 16 °C and electrical heater assists
the heat pump.
Set the fan speed by pressing the FAN button. The LED display
F1
shows (low),

OPERATION

F2
(medium) or
Page 8
F3
(high).