Pat Testing; General Safety Requirements; Setting Up The Remote Control - Prem-I-Air EH0533 Manual

does not engage properly with the drain tube in the wall, leakage
will occur.
L. If the mains lead is fitted with a Schuko plug (with two round

SETTING UP THE REMOTE CONTROL

Open the battery compartment cover, fit two AAA batteries, and
replace the cover. Immediately after fitting the batteries, the HEAT
and COOL icons on the handset display will flash alternately.
Press the MODE button whilst the HEAT icon is shown. If this
step is not performed, it will not be possible to select HEAT
from the remote control handset. Repeat this procedure every
time the batteries are replaced.
Press the CLOCK button, then, using the HR (hour) and MIN
(minute) buttons, set the clock to the correct time. Then press the
CLOCK button again. The remote control handset is now ready for
use.
When used in an office environment, this product must be safety-
tested yearly by a qualified electrician (PAT Tested) in order to
comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a
domestic environment.

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified
electrician at least once every 10 years or at every change of
occupancy. For office and retail premises, and buildings such as
village halls, the wiring must be inspected at least once every 5
years. It is recommended that all building be fitted with smoke
alarms (it is mandatory for new buildings).
pins), either fit the 13 A plug
adaptor provided, or remove the
Schuko plug and fit a 13 A plug.
Alternatively, remove the plug
and wire to the mains supply via a
switched fused spur.
HANDSET.

PAT TESTING.

Page 6