Asko T208H.W.AU Instructions For Use Manual page 32

The heat pump fi lter has to be correctly placed into its slot. Otherwise, the heat exchanger installed inside
the dryer may be clogged.
32
Use a soft dry cloth to also clean the heat pump
5
fi lter housing and net.
Lower part of the hosing contains a strainer which
shall be cleaned thoroughly.
Clean the heat pump fi lter housing and net after
every 10 drying cycles or if necessary.
With automatic heat pump net fi lter cleaning (only
available in some models), a few drops of water may
drip on the fl oor after the fi lter is removed; therefore,
lay a cloth on the fl oor.
Clean the heat pump cooling fi ns with a vacuum
6
cleaner (with a brush attached). This should be
done very gently to prevent damaging the very thin
cooling fi ns.
Heat pump cooling fi ns should be cleaned
occasionally or if it necessary.
Reinstall the heat pump fi lter into the housing.
7
Reinstall the inside cover and rotate the levers
downwards.
Close the outer cover.