Table of Contents
Advertisement
Chapter 4 Changing Patches in the Desired Sequence
Inserting a Chain Step
This operation inserts a patch into the specified location of a
chain.
fig.4-11
1
2
3
4
1
2
2
3
4
A maximum of 32 steps can be set in a chain. If the chain
already contains 32 steps, the patch at step 32 will be deleted.
1. Press [PATCH NUMBER
] to select the step in which the patch is to be inserted.
2. Press [PARAMETER
fig.4-12
01-02 InsertStep
OK? [WRITE/EXIT]
3. Press [WRITE].
The step is inserted with the same patch, and later steps
are each moved back one place.
* If you decide not to execute, press [EXIT].
4. Turn [PATCH/VALUE] to select the patch in the new step.
Deleting a Chain Step
This operation deletes an unneeded patch from a chain.
fig.4-13
1
2
3
4
1
2
3
4
1. Press [PATCH NUMBER
to select the step from which the patch is to be deleted.
2. Press [
PARAMETER].
fig.4-14
01-02 DeleteStep
OK? [WRITE/EXIT]
3. Press [WRITE].
The step is deleted, and later steps are each moved
forward one place.
* If you decide not to execute, press [EXIT].
66
5
5
6
] or [PATCH NUMBER
].
5
6
5
] or [PATCH NUMBER
Playing with a Patch Chain
(Chain Play)
1. Press [CHAIN].
[CHAIN] will light, and you will enter Chain Play mode.
fig.4-15
U01 CHAIN
01
Conga
2. Press [GROUP +] or [GROUP -] to select the chain group
to be used. You can select the chain group by striking a
pad B1–C5 while holding down [PATCH SEL]. Pads B1–
C5 correspond to chain groups 1–10 respectively.
fig.4-16
U02 CHAIN
01
TalkingDrm
In the case of a chain group which has no patch, "--" will be
displayed at the upper right of the screen.
3. Press [PATCH NUMBER
] or turn [PATCH/VALUE] to call up the patches to
be used in each selected step in the chain. You can call up
the patches by striking a pad A2 or A4 while holding
down [PATCH SEL]. Striking the pad A2 will decrease
the chain step, and striking the pad A4 will increase it.
fig.4-17
U05 CHAIN
01
Vibraphone
4. When the performance is finished, press [CHAIN]; you
will return to normal Play mode.
[CHAIN] will go dark.
* [EXIT/MODIFY CLEAR] operates as modify clear (p. 19),
and cannot make Chain Play mode off.
]
You can use foot switches to call up patch chains. For details,
refer to "Settings for the Foot Switches" (p. 71).
01-01
05-01
] or [PATCH NUMBER
05-02
Advertisement
Table of Contents
