Chapter 6 Connecting MIDI Devices
Cutting the Connection Between
the Sound Generator and the
Pad Controller (Local Control)
This setting is required when you wish to record your pad
performance on an external MIDI sequencer.
The performance data from the pad, rather than being sent
directly to the sound module section (Local Control Off), is
first sent to the external sequencer, and then on to the HPD-
15's sound module.
fig.6-09.e
HPD-15
Trigger
MIDI
Converter
Local Control: OFF
Soft Thru: OFF
Sound Generator
: Performance data flow route
If you make connections and record as shown, with a setting
of Local On, duplicate notes will be re-transmitted to the
HPD-15 and will not be played correctly. If you turn on Soft
Thru (p. 79) and make connections as shown in the diagram,
MIDI messages will create a loop, and the system will not
play correctly. Be sure to turn off Soft Thru as well.
1. Press [SYSTEM] to make it light.
2. Press [
PARAMETER] or [PARAMETER
display the following screen.
fig.6-10
MIDI
LocalControl
3. Turn [PATCH/VALUE] to select ON/OFF.
4. When you are finished setting, press [SYSTEM] or
[EXIT].
LocalControl: OFF, ON
When Local Control is set to "OFF," the internal sound
generator does not sound, even when the pad is struck.
80
MIDI OUT/THRU
External
MIDI IN
Sequencer
] to
ON
Saving Data to an External
MIDI Instrument
The data in the HPD-15 can be transmitted either singly or
collectively to a sequencer (or another HPD-15). The
operation of transmitting this data is called a "Bulk Dump";
receiving this data is called a "Bulk Load."
Transmitting (Bulk Dump)
The HPD-15 transmits stored data to a sequencer.
Use a MIDI cable to connect the HPD-15's MIDI OUT
connector to the MIDI IN connector of the external sequencer
or the other HPD-15.
fig.6-11.e
MIDI IN
External Sequencer
1. Press [SYSTEM] to make it light.
2. Press [
PARAMETER] or [PARAMETER
display the following screen.
fig.6-12.e
MIDI
[WRITE]
BlkDmp
or
MIDI
[WRITE]
BlkDmpU0101-0101
blinking
3. Turn [PATCH/VALUE] to select the contents that you
wish to transmit.
4. Put the receiving sequencer in record mode. When you
wish to transmit to another HPD-15, put the receiving
HPD-15 in play mode.
MIDI OUT
HPD-15
ALL
] to