Check The Torque Of The Wheel Nuts; Starting And Stopping The Engine; Setting The Reel Speed; Cutting Grass With The Machine - Toro Reelmaster 5410-D Operator's Manual

Check the Torque of the
Wheel Nuts
Torque the wheel nuts to 94 to 122 N-m (70 to 90 ft-lb).
after 1-4 hours of operation and again after 10 hours
of operation. Torque every 250 hours thereafter.
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Starting and Stopping the
Engine
Important:
The fuel system will automatically
bleed itself when any of the following situations
occur:
•
Initial start up of a new machine.
•
The engine has ceased running due to lack of fuel.
•
Maintenance has been performed upon the fuel
system components.
Starting the Engine
1. Sit on the seat, keep your foot off of the traction
pedal so that it is in Neutral, engage the parking
brake, set the engine speed switch to the Mid
position and ensure that the Enable/Disable
switch is in the Disable position.
2. Remove your foot from the traction pedal and
make sure the pedal is in the Neutral position.
3. Turn the ignition key to the Run position.
4. When the glow indicator dims, turn the ignition
key to the Start position. Release the key
immediately when the engine starts and allow it
to return to the Run position. Allow engine to
warm up (without load), then move the throttle
control to the desired position.
Stopping the Engine
1. Move all controls to Neutral, set the parking
brake, move the engine speed switch to the low
idle position and allow the engine to reach low
idle speed.
2. Turn the key to the Off position and remove it
from the switch.

Setting the Reel Speed

To achieve a consistent, high quality-of-cut and a
uniform after cut appearance, it is important that you
set the reel speed to the proper setting. Adjust the
reel speed as follows:
1. In the InfoCenter, under the settings menu,
enter the blade count, mow speed and HOC to
calculate the proper reel speed.
2. If further adjustments are required, in the
settings menu, scroll down to the F Reel RPM,
R Reel RPM or both.
3. Press the right button to change the reel speed
value. As the speed setting is changed, the
display will continue to show the calculated reel
speed based on blade count, mow speed and
HOC, but the new value will also be displayed.
Note:
The reel speed may need to be increased
or decreased to compensate for varying turf
conditions.
Cutting Grass with the
Machine
Note:
Cutting grass at a rate that loads the engine
promotes DPF regeneration.
1. Move the machine to the job site and align the
machine outside the cutting area for the first
cutting pass.
2. Ensure that the PTO switch is set to the
position.
3. Move the lever for the mow-speed limiter
forward.
4. Press the throttle-speed switch to set the engine
speed to
HIGH IDLE
5. Use the joystick to lower the cutting units to the
ground.
6. Press the PTO switch to prepare cutting units
for operation.
7. Use the joystick to raise the cutting units off the
ground.
8. Begin moving the machine toward the cutting
area and lower the cutting units.
Note:
Cutting grass at a rate that loads the
engine promotes DPF regeneration.
9. When you complete the mowing pass, use the
joystick to lift the cutting units.
10. Perform a tear-shaped turn to quickly line up for
your next pass.
29
DISABLE
.