Set Up Sonar - Humminbird 1100CI Series Installation And Operation Manual

Set up Sonar

Use the instructions below to select sonar sources for each control head. Before you can select frequencies from the network, the
control heads must be set up with their connected transducer.
1. Set up the Transducer
The following instructions are only required the first time you set up each control head with an attached transducer.
1. Main Menu: Press the Menu key twice.
2. Select the Sonar tab > Connected Transducer (or Transducer Select).
3. Press the Right or Left Cursor keys to scroll through the compatible transducers for that model. Select the transducer that is
attached to the control head.
4. Repeat steps 1 to 3 for each control head.
If there is not a transducer attached to a control head, you can skip this section for that control head.
2. Turn on/off CHIRP Mode
A CHIRP unit can use sources from any other control head on the network. If a unit is not CHIRP-capable, it cannot use sources
connected to the CHIRP control head (unless CHIRP Mode is turned off).
1. Main Menu: Press the Menu key twice.
2. Select the Sonar tab > CHIRP Mode.
3. Select on or off.
In the following example, the HELIX 9 SI GPS Network Source Setup dialog box shows the HELIX 12 CHIRP SI GPS transducer is
listed, but it is grayed out to show it cannot be used by the HELIX 9 (because the HELIX 9 it is not CHIRP-capable). However, the
sonar source on the CHIRP unit will be available to the HELIX 9 if you turn off CHIRP mode on the HELIX 12.
sonar sources
Sonar Sources
Network Source Setup Dialog Box (HELIX 9 SI GPS)
18
grayed-out source