Table of Contents
Advertisement
• Note (Pad Note)
Specifies the note number of the pad when Pad Set is set to
"User."
Value: C-1–G9
• Velocity (Pad Velocity)
When Pad Set is set to "User," specifies the loudness of the
sound produced by striking the pad.
If you set this to REAL, you can vary the dynamics of the sound
by varying the strength with which you press the pad.
Value: REAL, 1–127
• Pad Common Velo (Pad Common Velocity)
Specifies the loudness of the sound produced when you strike the
pad. If you set this to "REAL," you can vary the loudness by varying
the striking force. This setting is common to all sixteen pads.
* If you have specified multi-velocity (p. 170), that setting will be used.
Range: REAL, 1–127
• Roll Resolution
Specifies the spacing of the notes when you use the pads to play
a roll.
Value:
,
,
,
,
• Pad Sens (Pad Sensitivity)
Specifies the touch sensitivity of the pad.
Value
Light:
Specifies a light playing touch for the pads. Even light
strikes on the pad will produce loud sounds, compared
to the Medium setting.
Medium: Specifies the standard playing touch for the pads. This
provides the normal playing feel.
Heavy: Specifies a heavier playing touch for the pads. Since
loud sounds will be produced only when you strike the
pads more strongly than usual, this produces the
sensation that the playing touch is heavier.
• Aftertouch Sens (Aftertouch Sensitivity)
Specifies the Aftertouch sensitivity. Higher values will allow
Aftertouch to be applied more easily. Normally you will leave
this at "100."
Value: 0-100
4. If you want to save your settings, perform the Write
procedure.
Mode
Parameter
Performance
Pad Common Velo
mode
Pad Sens
Aftertouch Sens
Roll Resolution
Pad settings other
than the above
Patch
All pad settings
mode
* The Write procedure varies depending on the selected mode or
parameter.
5. When you have finished making settings, press [EXIT].
,
,
,
Write procedure
Press [8 (System Write)]
* Save as System parameters
Press [WRITE].
* Saved as performance parameters.
Press [8 (System Write)].
* Saved as System parameter.
Multi-Velocity
You can use the sixteen pads to play a specified note at sixteen
velocity levels. The same note number will be sounded by all sixteen
pads. This function can be useful when you are having difficulty
inputting the velocities you intend.
1. From the Pad Setting screen, press [7 (Multi Velo)].
The Multi Velocity Setup window will appear.
fig.Pad02_50
2. Turn the VALUE dial or use [INC] [DEC] to specify the note
number.
3. Press [8 (Select)].
The window will close, and a check mark will be added to [7
(Multi Velo)].
If you want to turn off multi-velocity, press [7 (Multi Velo)] once
again to remove the check mark.
Assigning a Pattern to a Pad
(RPS Function)
The Fantom-S lets you assign a previously recorded phrase to a pad
as a pattern, and play it by pressing that pad. For details, refer to
"Playing a Phrase at the Touch of a Finger (RPS Function)" (p.
172).
Using the Pads to Play
Rhythms
The Fantom-S lets you assign rhythm patterns and/or rhythm
sounds to the pads and play them by pressing the pads. For details,
refer to "Playing Rhythms" (p. 112).
Using the Pads
137
Advertisement
Table of Contents
