Table of Contents
Advertisement
Error Message
Stacker 2 disc
height error
Stacker 3
installed
Stacker 4 full
Stacker 4 open
Too many discs
ST1, ST2
Too many discs
Stacker 1 & 2
Transferred disc
detection error
Wait a moment
and try again
Write error
Remedy
The Stacker 2 disc height has changed compared to before
the disc cover was opened.
Press the
button or CANCEL button to remove all discs
remaining in Stacker 2.
Remove Stacker 3, and close the disc cover. Stacker 3 is not
used in PIN Controlled Mode and Security Mode.
The initialization operation cannot be performed because
Stacker 4 is full.
Remove the discs from Stacker 4.
The disc cannot be ejected because Stacker 4 is full.
Remove the discs from Stacker 4.
Close Stacker 4.
Remove excess discs so that the height of the discs in the
indicated stacker is below the red line of the stacker, and
then close the disc cover.
The total disc height of Stacker 1 and Stacker 2 exceeds the
red line in the stacker.
Reduce the number of discs in Stacker 1 or remove all the
discs from Stacker 2.
A disc could not be detected after transfer to a printer or
drive. Turn off the power, and then turn it on again. (The
administrator user number and PIN must be entered to turn
off the power.) If the same error message still appears, repair
is required. Please contact Customer Support.
Press the
button or CANCEL button. Do not unlock the
disc cover repeatedly within a short time. Wait a moment
before unlocking.
Processing of the job is paused. See "Disc writing problems"
on page 127 in this guide, and after removing the cause of
the error, restart the job. (See "Resuming jobs" on page 74 in
this guide for the job restarting procedure.)
Troubleshooting
Notification
Sound
125
Advertisement
Table of Contents
