Precautions For Transporting Your Product - Epson Disc producer PP-100N Security Administrator's Manual

Precautions for transporting your product

When transporting this product, be sure to use the original box and protective materials to protect it from an impact,
etc. See PP-100N Security Setup Guide for details on the handling of protective materials.
• Make sure that no discs remain inside the product.
• Never remove the ink cartridge(s) currently in use. The print head may dry out, and
printing may become no longer possible.
• The disc cover key should not be transported with the product. It should be kept by the
administrator.
• When attaching protective materials and transporting the product, do not tilt the
product or turn it upside down. Make sure that it is oriented horizontally.
• Make sure that the product is lifted by two people.
result in the product being dropped, or deformed and damaged.
Furthermore, when putting down this product, take care not to trap a finger between
the product and installation surface.
• When lifting this product, make sure that, you sufficiently bend your knees, and your
posture is such that excessive stress is not placed on your body.
An unnatural posture when lifting the product may result in an injury, or the product
being damaged.
• When moving the product, do not tilt it 10 or more degrees in a forward, backward
direction, or sideways direction.
The dropping or other mishandling of the product may result in an accident.
• Do not place a heavy object on the top of the product.
Subjecting this product to excessive force may result in a malfunction.
However, it is possible to place one unit of this product on top of another. In such a
case, make sure the tops and bottoms are oriented the same, and the exterior of the
units are aligned. At the same time, take sufficient care to prevent a unit from dropping
or falling. Also, do not place more than one unit on top of another.
1
Restore the product to the initial state.
See "Restoring to initial state" on page 107 in this guide for how to restore the product to the initial state.
2
Press the power button to turn off the power.
3
After the Power LED goes out, disconnect the power cord and Ethernet cable.
4 Remove the authentication keypad.
See "Connecting the authentication keypad" on page 21 in this guide for the removal procedure.
Maintaining Your Product
The weight of this product is approximately
25.0 kg. When this product is lifted, it should
be lifted on both sides by two people holding
the recesses on the sides as shown in the
illustration on the left. Holding any part other
than the ones indicated in the illustration on
the left when carrying the product may result
in damage to the product. In particular,
carrying the product while the disc cover, ink
cartridge cover, or Stacker 4 is open may
117