Controls & Connections - Harman Kardon HKTS 7 Service Manual

SUB-TS7
SUB-TS7 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS
SUBWOOFER
¡
FILTER
ON
™
MIN
OFF
£
ON
AUTO
¢ REVERSE
NORMAL
∞
SUB R
LINE
LEVEL
IN
§
L
H
I
G
H
¶
L
E
V
E
L
R
•
OUT
ª
IMPORTANT: CONNECT STRIPED WIRE
TO RED ( ) SPEAKER TERMINAL.
‚
¡ Subwoofer-Level Control
™ High-Cut (Low-Pass) Filter Switch
£ Music-Sense On/Off Switch
¢ Phase Switch
¡ Subwoofer-Level Control: Volume
may be adjusted using the Subwoofer-
Level Control. Turn the control clockwise
to increase the SUB-TS7's volume, or
counterclockwise to decrease it.
™ High-Cut (Low-Pass) Filter Switch:
Placing this switch in the ON position acti-
vates circuitry that cuts out all audio input
signals above 120Hz. This allows the SUB-
TS7 to focus its power on reproducing the
low-frequency portion of the signal, avoiding
SUB-TS7 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS
LEVEL
MAX
PHASE
L
IN
∞ Line-Level Subwoofer (SUB) Input
§ Line-Level Full-Range Inputs
¶ Speaker-Level Outputs
• Speaker-Level Inputs
inefficiency and distortion. Engage this filter
when using the Speaker-Level Inputs •,
or when using the Line-Level Full-Range
Inputs §, unless your receiver or processor
processes its line-level output using a low-
pass filter. The filter has no effect when the
SUB Input ∞ is used.
£ Music-Sense On/Off Switch: When
placed in the AUTO position, and when the
Master Power Switch ª is turned on, the
SUB-TS7 will automatically turn itself on or
SUB-TS7
C A U TIO N C A U TIO N
R ISK OF ELEC TR IC SH O C K R ISK OF ELEC TR IC SH O C K R ISK OF ELEC TR IC SH O C K
"WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE T 2.5A L/250 VOLT FUSE"
"AVERTISSEMENT: UTILISEZ UN FUSIBLE DE RECHANGE DE MEME
TYPE T 2.5A L/250V"
POWER
ª Master Power Switch
‚ AC Power Cord
place itself in the Standby mode, depending on
whether it is receiving an audio signal. When
this switch is placed in the ON position, the
SUB-TS7 will remain on, whether or not it is
receiving an audio signal.
An LED located on top of the SUB-TS7 indi-
cates whether the SUB-TS7 is in the ON or
STANDBY state when used with the Music-
Sense On/Off Switch £ in the AUTO
position. The LED is lit blue to indicate that
the SUB-TS7 is receiving an audio signal
4
harman/kardon
For use with
HKTS 7 System
D O NO T OPE N D O NO T OPE N D O NO T OPE N
AC 120V~60Hz
5